The tile grout should
be scraped out with a Grout Getter about 1/8” to
3/16’ below
the top edge of the tile. This will allow enough
room for the new grout to substantially fill in the
grout joints.
The old remaining grout in the joints will act as
a good roughed-up bonding surface for the new grout
to adhere to.
Be sure to thoroughly clean out or vacuum the loose
particles out of the grout joints before installation
of the new tile grout.
The pictures show removal of sanded tile grout with
the triangular cutting blade and the diamond cutting
blade is removing non-sanded grout out of a 1/16” tile
joint. |
Shopping Cart